Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.2.1 (53-1000430-01)

3-4 Access Gateway Administrator’s Guide
Publication Number: 53-1000430-01
Disabling Access Gateway mode
3
Using the CLI to disable Access Gateway mode
After you disable Access Gateway mode, use the instructions in the Fabric OS Administrator’s Guide to
reconfigure the switch and join it to the fabric.
To disable Access Gateway mode
1. Connect and log in to the switch.
2. Enter the ag --modeshow command to verify that the switch is in Access Gateway mode.
3. Enter the switchDisable command to disable the switch.
4. Enter the ag command with the --modedisable operand to disable Access Gateway mode.
The switch automatically reboots and comes back online using the fabric switch configuration; the
Access Gateway parameters, such as F_Port to N_Port mapping, failover, and failback policies are
automatically removed.
5. Enter the ag --modeshow command to verify that Access Gateway mode has been disabled.
Note
Disabling Access Gateway mode clears the current Access Gateway mode configuration and reboots the
switch.
switch:admin> ag --modeshow
Access Gateway mode is enabled
switch:admin> switchdisable
Note
To save the Access Gateway configuration, use the configUpload command before
proceeding with the next step.
switch:admin> ag --modedisable
switch:admin> ag --modeshow
Access Gateway mode is NOT enabled
Note
Use the configDownload command to restore a previous fabric configuration.