Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.2.1 (53-1000430-01)

Access Gateway Administrator’s Guide D-5

Publication Number: 53-1000430-01

Access Gateway system messages

AG-1001

Message

Probable

Cause

Indicates that the fabric port to which Access Gateway is connected does not support NPIV.

Recommended

Action

Enable NPIV on the port connected to the Access Gateway using the portCfgNpivPort command on

the fabric switch. Refer Fabric OS Command Reference Manual for more information on this

command.

Severity ERROR

AG-1002

Message

Probable

Cause

Indicates that the F_Ports could not be failed over because no other N_Ports are configured or that the

fabric was unstable during the failover attempt.

Recommended

Action

Verify whether or not other N_Ports are configured.

If the message persists, run supportFtp to set up automatic FTP transfers; then run the supportSave

command and contact your switch service provider.

Severity WA RN I NG

AG-1003

Message

Probable

Cause

Indicates that an F_Port could not be failed over to another N_Port because no other N_Ports were

connected to the same fabric as N_Port that went offline.

Recommended

Action

Connect two or more N_Ports to the same fabric and then enabled failover on these N_Ports using the

ag --failoverenable command.

<timestamp>, [AG-1001], <sequence-number>,, ERROR, <system-name>,

N_Port <port> is connected to a fabric port that does not support NPIV

<timestamp>, [AG-1002], <sequence-number>,, WARNING, <system-name>,

Unable to find alternate N_Port during fail over for N_Port <port>

<timestamp>, [AG-1003], <sequence-number>,, WARNING, <system-name>,

Not able to fail over N_Port <port>. Fail over across different

fabric is not supported.