Brocade Access Gateway Administrator's Guide Supporting Fabric OS v7.0.0 (53-1002156-01, April 2011)

66 Access Gateway Administrator’s Guide
53-1002156-01
Considerations for the Brocade 6510
3
Fabric OS command support
This section describes how Fabric OS commands are supported on the Brocade 8000 in AG mode.
• The following commands are not supported on the Brocade 8000 in AG mode:
- ag --pgmapadd
- ag --pgmapdel
- ag --persistentalpaenable
- ag --printalpamap
- ag --deletepwwnfromdb
- ag --clearalpamap
- ag --wwnmapshow
- ag --addwwnmapping
- ag --delwwnmapping
- ag --addwwnpgmapping
- ag --delwwnpgmapping
- ag --wwnmappingenable
- ag --wwnmappingdisable
- ag -delwwnfailovermapping
- agautomapbalance
- portcfgnport
• The following commands have restricted usage, mostly because the Brocade 8000 contains
only eight Fibre Channel ports and does not support the Automatic Port Configuration policy:
- ag --pgcreate
- ag --policyenable
- ag --policydisable
- portcfgdefault
• To enable or disable FCoE ports, use fcoe --enable and fcoe --disable instead of portdisable
and portenable.
• The portcfgdefault command resets the degraded state and NPIV PerPort and clears the
BufferLimitedMode on a port. For other AG platforms, this command restores the port
configuration to factory default values.
Considerations for the Brocade 6510
The Brocade IB 6510 can function in either Fabric OS Native mode or Brocade Access Gateway
mode.The switch is shipped in Fabric OS Native mode. The 6510 is not supported in a cascaded
configuration, either as an core or edge switch.