Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

180 Fabric OS Command Reference Manual

53-1000436-01

fcipChipTest

Tests functionality of components in the FCIP complex.

Synopsis fcipchiptest [--slot slotnumber][-testtype type][-unit number]

Description Use this command to verify the internal registers and memory of the network processor, FCIP FPGA,

compression processor, and GigPHY.

This command is supported only on Brocade FR4-18i blades and Brocade 7500 platforms.

Operands This command has the following operands:

--slot slotnumber Specifies the slot number on which the diagnostic operates. The default is 0

and operates on fixed-port-count products.

-testtype type Specifies the test type to run. By default, the command runs all tests. Valid

tests include:

0 All tests

1 Network processor SRAM test

2 FCIP FPGA internal register test

3 FCIP FPGA interrupt test

4 FCIP FPGA checksum test

5 Compression engine MBIST and LBIST

-unit number Specifies the GbE port to test. By default, all GbE ports in the specified

slotnumber are used. Valid number values include:

0 GbE port 0

1 GbE port 1

2 All GbE port

Examples To run all tests on slot 7 and GbE port 1:

switch:admin> fcipchiptest --slot 7 -unit 1 -testtype 0

Running fcipchiptest ..............

Test Complete: fcipchiptest Pass 1 of 1

Duration 0 hr, 1 min & 15 sec (0:1:15:351).

passed.

Diagnostics When a failure is detected, the test might report one or more of the following error messages:

CHIP_TEST_ERR

CHIP_TEST_CHIP_INIT_ERR

CHIP_TEST_IMAGE_VER_ERR

CHIP_TEST_TIMEOUT_ERR

CHIP_TEST_HEARBEAT_ERR

CHIP_TEST_INVALID_RESULT