HP Surestore Auto Path Virtual Array for Windows NT Installation and User's Guide

autopath set device
64 HP Auto Path XP: User’s Guide (Windows NT/2000)
autopath set device
Set load-balancing policy or preferred path
Syntax autopath set device=device_number { policy=policy_name |
path=path_number }
device_number The Auto Path index number shown in the autopath
devices command line display.
policy_name The load balancing policy name. For a list of load
balancing policies, see “Setting the load balancing
policy” (page 42).
path_number The preferred path number.
Description The autopath set device command sets the load balance policy for the
device specified by the device number.
If no load balancing is set for a device, the autopath set device command
sets the preferred path to the device.
Examples
HP Auto Path> autopath set device=1 policy=round_robin
Device Name: HP OPEN-3
Device Serial No. : 0400756000E2
Change Load Balance policy (y/n) ? y
Load Balance policy changed. Verify by issuing "autopath" command
HP Auto Path> autopath set device=1 path=2
Device Name: HP OPEN-3
Device Serial No. : 0400756000E2
Controller Port No. : 22
Path Scsi Address : 3.4.1.0
Change Preferred Path (y/n) ? y
Preferred Path changed. Verify by issuing “autopath” command