HP StorageWorks Auto Path for AIX V04.40 Installation Guide (B7949-96008, August 2004)

16 HP StorageWorks Auto Path for AIX: Installation Guide
Installation procedure
Configure the disk array LUNs to be accessible through at least one port in
each cluster of the array—one port in CL1 and the other in CL2.
Make the appropriate connections between the host HBAs and the disk
array ports.
Configure host bus adapters (HBAs) and switches. See the HBA product
documentation for the configuration method and settings. Verify that the
Fibre Channel connection method (such as Fabric or AL) matches the
settings.
Important Auto Path will not install if the above steps for connecting to an XP array
are not completed and hdisk definitions representing XP LUNs are not
present on the system.
Install VisualAge C++ (version 5.0.0.0 or later) filesets on the host if
required. AIX 4.3.3 software may be obtained at:
http://www-1.ibm.com/support/docview.wss?org=SW&doc=4001173
For AIX 5.1 and AIX 5.2, the software components are available on their
respective install media.
To install Auto Path:
1. Log in as root.
2. If a license key file has been provided, save it as the following file:
/var/tmp/hdlm_license
Otherwise, enter the license key as follows:
Create the /var/DLM directory:
# mkdir /var/DLM
Example
# echo "123456789ABCDEF" > /var/DLM/dlm.lic_key
where “123456789ABCDEF” is the license key number.
Optional Use a text editor to enter the key in the /var/DLM/dlm.lic_key file.