3.7.0 HP StorageWorks HP Scalable NAS File Serving Software installation guide HP Scalable NAS for Linux (AG513-96004, October 2009)

the hostname or IP address of the first FC switch. Repeat this procedure to specify
the remaining FC switches, including cascading switches.
SNMP Community String. The default SNMP community string for HP Scalable NAS
is private. If you want to use a custom community string, enter the appropriate
value here. The SNMP community string must be set to the same value on HP Scalable
NAS and on the SAN switches configured above.
When you have completed the information, go to the Storage Settings tab (see
Storage Settings tab, page 41).
Web management-based fencing
When you select either iSCSI storage or Fibre Channel storage with Web
management-based fencing, the SAN & Fencing tab will refresh and ask you for
configuration information. Enter the appropriate information for the Remote
Management Controller associated with the server that you used to connect to the
Management Console.
NOTE:
Later in this procedure the complete cluster configuration will be exported to the
other servers that will be in the cluster. During the export, HP Scalable NAS will,
where possible, use the information that you specified on the SAN & Fencing tab
to configure Web management-based fencing on the other servers. If a particular
entry on the SAN & Fencing tab did not apply to all servers, HP Scalable NAS will
ask for that information for each of the other servers.
The Remote Management Controller tab asks for information about the controllers
associated with your servers.
HP Scalable NAS File Serving Software installation guide 37