3.7.0 HP StorageWorks HP Scalable NAS File Serving Software installation guide HP Scalable NAS for Linux (AG513-96004, October 2009)

Additional required OS packages
On RHEL5 systems, HP Scalable NAS requires that the following packages be
installed. Most of the packages are included in the “default” server installation.
• lm_sensors-2.10.0-3.1.x86_64.rpm
• net-snmp-5.3.1-24.el5.x86_64.rpm
• samba-3.0.28-0.el5.8.x86_64.rpm
NOTE:
Samba releases later than 3.0.32 are not supported with HP Scalable NAS.
• ecryptfs-utils-44 (or greater)
• libnl-1.0-18.4.x86_64.rpm
For SLES10 systems, no additional packages need to be installed.
2. Build the kernel (optional)
NOTE:
If you will be using an HP Scalable NAS binary kernel, you can install it later as
specified in the installation procedure in Chapter 2.
If you need to build the kernel from source, take these steps:
1. Complete the following steps in the installation procedure in Chapter 2:
• 4. Verify downloaded RPMs , page 25
• 5. Install the kernels RPM , page 26
2. Build the kernel using the appropriate source kernel RPMs from the kernels RPM
that you just installed. See Appendix B, page 61 for more information.
3. HBA drivers and HP Scalable NAS
When configuring the operating system, you will need to consider whether the HBA
driver should be loaded either during the initial booting of the kernel or when HP
Scalable NAS is started. The following scenarios describe the appropriate action for
Install the operating system56