HP Management Integration Framework Administrator Guide (T5494-96539, October 2012)

5. After the change is saved, click Restart Service. The Management Integration Framework
software will bind to the specified IP address.
Logging in to the configuration interface
Considerations
• Viewing a Management Integration Framework interface requires a supported browser and
Flash Player plug-in. Supported browsers and Flash Players are listed in the HP Enterprise
Virtual Array Compatibility Reference.
• HP recommends using qualified user names. See Login user names.
• The Management Integration Framework web server port number shown in the example is the
default, 2374. If the port number has been changed, you must enter the new port.
• When browsing from a server which is running Windows Server 2008, the server's enhanced
security level must be turned off.
Procedure
1. Browse to https://<machine_name or IP address>:2374/Configuration.
2. Enter your user name and password.
3. Click OK.
Resetting or replacing HP P6000 EVA management modules
HP P6000 EVA storage systems with array-based management lose Management Group settings
(if any) when their management modules are reset or replaced. To avoid losing the settings, perform
the following steps before and after resetting or replacing a management module.
Before resetting or replacing
1. If necessary, install the Adobe Flash Player plug-in required to browse to HP Management
Integration Framework. Supported browsers and Adobe Flash Players are listed in the HP
P6000 Enterprise Virtual Array Compatibility Reference.
2. Log on to HP P6000 Command View on the storage system by browsing to
https://<storage system IP address:2374>.
3. Select Server Options > Other Options > Configure management infrastructure. If necessary,
install the Management Group certificate (See help in the communication error message).
4. Locate and record the name of the Management Group on the Service State pane in the
Configuration window. If it contains the same name as the management module, then
Management Groups are not configured on the storage system.
5. Click Discovery to expand the Discovery section and record the following:
• Discovery URI settings
• Registry Update Addresses
After resetting or replacing
1. Log on to the storage system again.
2. Select Server Options > Other Options > Configure management infrastructure.
3. Click Discovery to expand the section.
If the Discovery URI and Registry Update Addresses values are the same as those you recorded
before, skip to step 6.
4. Set the Discovery URI and Registry Update Addresses to the values you recorded before.
5. Click Save Changes > OK > Restart Service.
6. Return to HP P6000 Command View and select Server Options > Configure management
group.
7. Select the name of the management module.
22 Using the configuration interface