HP Management Integration Framework Administrator Guide (T5494-96539, October 2012)

Log file max size

This general setting establishes the maximum size of a Management Integration Framework log

file. A new log file is started when the maximum size is exceeded.

• Typical use. To increase the size of the log file. This setting is used mostly by HP support

personnel.

• The default is 10 MB.

• If you change the setting, it must be in the range of 1 to 100 MB.

Logging level

This general setting specifies the level of detail that is recorded in a Management Integration

Framework log file.

• Typical use. To change amount of detail being recorded about the Management Integration

Framework service. Increasing the detail is helpful when troubleshooting. This setting is used

mostly by HP support personnel.

• The default is 1 (least detail).

• If you change the setting, it must be in the range of 1 to 4 (most detail).

Secured web service port

This general setting establishes the port number for the web service interfaces which are served

using secure HTTPS protocol.

• Typical use. To accommodate environments where corporate policy or network infrastructure

(firewall, proxy, etc.) requires specific ports be used instead of allowing the Management

Integration Framework to pick free ports. The system administrator must specify the port for

the Management Integration Framework to use and then configure the firewall to allow the

port.

• The default setting is 0 (zero). A zero in a port number field indicates that the Management

Integration Framework can automatically assign the port number.

• If you specify a port number, it must be in the range of 1024 to 65535.

• The system administrator must pick a port that will be free every time the Management

Integration Framework starts, otherwise, the web service will not be available.

Unsecured web service port