HP P6000 Enterprise Virtual Array Compatibility Reference

FROM HP P6000 Command View version
9.4
9.4.1
1
10.0 10.1 10.2
10.2.1
2
10.3
10.3.1
3
10.3.2
4
9.3
• •
9.4
• • •
9.4.1
• •
10.0
• •
10.1
• •
10.2
• •
10.2.1
•
10.3
• •
2.1 HP P6000 Command View upgrade support
1
To upgrade from 9.3 to 9.4.1, upgrade from 9.3 to 9.4 and then apply the 9.4.1 patch.
2
To upgrade from 10.1 to 10.2.1, upgrade from 10.1 to 10.2 and then apply the 10.2.1 patch.
3
To upgrade from 10.2 to 10.3.1, upgrade from 10.2 to 10.3 and then apply the 10.3.1 patch.
4
To upgrade from 10.2 to 10.3.2, upgrade from 10.2 to 10.3 and then apply the 10.3.2 patch.
TO HP P6000 Command View version
This table shows upgrade support for HP P6000 Command View Software versions. A bullet (•) indicates you can perform an upgrade from the version in the
FROM column to the version in the TO column without removing the earlier version. A blank cell (or if an HP P6000 Command View Software version is not
listed) indicates an upgrade to a later version (without removing the earlier version) is not supported. For unsupported upgrade paths, you must remove the
previous version using Windows Add/Remove Programs, reboot the management server, and install the applicable version listed below.
NOTE: For supported upgrade paths, a reboot may occur automatically during the upgrade. During an upgrade, a reboot occurs only if files are marked for
deletion or services are in a disabled state. After a reboot, the user should start the installation again.
8