HP StorageWorks EVA Hardware Providers administration guide Windows 2003 (T1634-96052, February 2006)
Configuration procedures
Physically configure the servers and software as described b elow and in the manuals for
those products. See the overview diagram under the h eading Required co mponents .
Your HP representative may perform some installation and configuration tasks.
Configuration summary
You will perform the following tasks during configuration:
Windows CV w
orkstation:
• Install HP MPIO FF Failover M anager (if multipathing is required) .
• Use Comman
d View EVA to a ctivate the BC license.
VDS/VSS servers:
• Install Windows Enterpri se OS, FC HBAs, drivers and software.
• Install HP MPIO Full-Featured Failover (if multipathing is desired).
• Connect to the array’s FC SAN.
• Connect to the corporate Ethernet LAN (A firewall is optional but recommended.
The firewall must be open between servers.)
Disk array (Command View EVA):
• (VSS on
ly)Createasnapclonediskgroup(orusetheexistingproductiondisk
group).
• (VSS only) Create other disk groups as required by your application. (Exchange
requir
esadatadiskgroupandalogdiskgroup.)
24
Configuration