HP P6000 Command View Suite 10.3.2 Release Notes

Version

HP P6000 Command View Software Suite 10.3.2

Description

This document describes the HP P6000 Command View 10.3.2 release for server-based

management.

IMPORTANT: General references to HP P6000 Command View can also refer to earlier versions

of HP Command View EVA.

To determine which versions of array controller software support HP P6000 Command View , see

Table 2.0, “HP P6000 Command View interoperability support,” in the HP P6000 Enterprise

Virtual Array Compatibility Reference.

For more information about HP XCS, see the release notes for the specific XCS version.

Update recommendation

HP recommends that you upgrade to HP P6000 Command View 10.3.2 if HP P6000 Command

View 10.3 is installed already. If HP P6000 Command View 10.3.2 is already installed when HP

P6000 Command View 10.3.2 installation is initiated, HP P6000 Command View 10.3.2 will be

installed again.

NOTE: To apply HP P6000 Command View 10.3.2 patch, it is mandatory to first install HP

P6000 Command View 10.3 on the target machine.

If HP P6000 Command View 10.3 is not installed before installing HP P6000 Command View

10.3.2, the installation fails. The following error message appears:

The HP P6000 Command View Software Suite 10.3 needs to be installed on

the system in order to apply the 10.3.2 patch.