HP EVA to 3PAR StoreServ Online Import Migration Guide (T5494-96604, July 2013)

2. Select the HP EVA to 3PAR StoreServ Online Import tab.
3. In the left navigation pane, select a host.
You can select a host folder, an individual host, or a user defined host folder.
4. Click Add Migration.
The Add Migration from a Host Selection wizard runs.
5. Read the information on the Introduction screen, then click Next.
The Select explicit migration source screen is displayed.
6. Select the host that will be the source, then click Next.
The Confirm Explicit and Implicit Migration Sources screen is displayed.
7. Check the implicit and explicit host and virtual disk selections to ensure they are ready for
migration, then click Next.
The Confirm Your Migration Destination screen is displayed.
NOTE: If any object selected for migration is not ready for data migration, the appropriate
status is displayed in the Migration OK? field, and the Next button is disabled. In this case,
click Export Selections to save the selections information to a file for troubleshooting. Then
click Cancel to stop the migration wizard. Using the saved selections information, correct the
problem and run the migration wizard again.
8. Ensure the 3PAR Destination Storage System is ready for migration, then click Next.
The Configure Destination Volumes screen is displayed.
NOTE: If the Migration OK? status is not OK, the tooltip provides information on why the
migration cannot be performed until the necessary action is taken.
9. Set the Destination Virtual Volume Attributes.
a. Set the Configuration to Set individually.
b. Select the desired Destination Provisioning for the destination virtual volume.
c. Select the desired Destination Common Provisioning Group (CPG) for the destination
virtual volume.
d. To use these settings for all the virtual volumes, set the Configuration to Set all the same.
To use different settings for each volume, repeat the steps for each volume.
10. Click Next.
The Summary screen is displayed.
11. Review the summary information, then click Add Migration.
The Host HP EVA to 3PAR StoreServ Online Import Status Summary page is displayed with
the newly added migration in the list of Migrations in Progress. The Preparation status displays
a progress bar indicating that migration preparation is being performed.. When complete,
the Preparation status changes to Done, and the Completed button is displayed in Data Transfer,
indicating that the host must be unzoned from the EVA before beginning the migration.
12. Perform a LUN rescan on each host being migrated and ensure that the paths to the destination
3PAR storage system are correct.
13. Unzone the source EVA from the host.
14. When the host has been unzoned, click Completed.
The Data Transfer status displays the Start button.
15. Click Start to begin the migration.
A confirmation screen identifies conditions that must be met before beginning the migration.
IMPORTANT: Once a migration begins, it cannot be stopped.
Migrating a LINUX or a VMware host 17