HP EVA to 3PAR StoreServ Online Import Migration Guide (T5494-96571, January 2013)

18. When all the conditions have been met, click Start Data Transfer.
A progress bar indicates how much of the data has been migrated. The progress bar is
refreshed every 15 seconds.
19. Zone the host to the 3PAR destination storage system, establishing the data paths between
the host and the destination.
20. Bring the Windows host that was shut down back online.
The host now communicates with the destination 3PAR storage system.
21. When the migration is complete, the migration entry is deleted, and the Migration History is
updated with the information about the migration.
Migrating virtual disks presented to a non-Windows host
NOTE: Make sure you have zoned the non-Windows host to the 3PAR destination storage system
before performing the migration. For more information, see “Zoning a host to the destination 3PAR
storage system” (page 12).
1. In Command View, select the Storage Systems point of view.
2. Select the HP EVA to 3PAR StoreServ Online Import tab.
3. In the left navigation pane, select a virtual disk.
You can select a virtual disk folder or an individual virtual disk.
4. Click Add Migration.
The Add Migration from a Virtual Disk Selection wizard runs.
5. Read the information on the Introduction screen, then click Next.
The Select explicit migration source screen is displayed.
6. Select one or more presented virtual disks as the source virtual disks.
7. Click Next.
The Confirm Explicit and Implicit Migration Sources screen is displayed.
8. Ensure the implicit and explicit host and virtual disk selections are ready for migration, then
click Next.
The Confirm migration destination screen is displayed.
NOTE: If any object selected for migration is not ready for data migration, the appropriate
status is displayed in the object Migration OK? field, and the Next button is disabled. In this
case, click Export Selections to save the selections information to a file for troubleshooting.
Then click Cancel to stop the migration wizard. Using the saved selections information, correct
the problem and run the migration wizard again.
9. Ensure the 3PAR Destination Storage System is ready for migration, then click Next.
The Configure Destination Volumes screen is displayed.
NOTE: If the Migration OK? status is not OK, the tooltip provides information on why the
migration cannot be performed until the necessary action is taken.
10. Set the Destination Virtual Volume Attributes.
a. Set the Configuration to Set individually.
b. Select the desired Destination Provisioning for the destination virtual volume.
c. Select the desired Destination Common Provisioning Group (CPG) for the destination
virtual volume.
d. To use these settings for all the virtual volumes, set the Configuration to Set all the same.
To use different settings for each volume, repeat the steps for each volume.
20 Performing the data migration