HP StorageWorks Replication Solutions Manager V1.1 Release Notes (T3687-96026, June 2005)

2. Right click null.
3. Click delete.
Firewall configurations
A firewall between the replication manager ser ver and an enabled host is not supported. The server and
host agent cannot c ommunicate across the firewall.
A firewall between a browsing comp uter and the replication manager server is supported. You can
browse to the replication manager through a VPN tunnel.
Operational errors
Low-Level Refresh returns an error
When you perform a low-level refresh on a virtual disk or DR group, the replication mana ger may log
the message: Unable to complete the requested action because of an unexpected
error . This can occur when the replication manager is unable to discover the selected disk or DR group.
Resolution: check your storage array, and then retry the low-level refresh.
Table 1. shows the commands and GUI actions that perform low-level refresh.
Table 1 Low-level refresh actions and comm ands
In the CLUI: In the GU I:
set dr <dr group> refresh
virtual disks>actions>low-level
refresh
show dr <dr group> refresh
dr groups>actions>low-level refresh
set container <container> refresh managed sets>actions> low-level
refresh (for virtual disk and dr group
managed sets)
show container <container> refresh
show snapclone <snapclone> refresh
set vdisk <vd>refresh
show snapshot <snapshot> refresh
Host volume remount fails after an unclean unmount
If a host volume is uncleanly unmounted, such as during an unplanned failover, and you tr y to remount it
using the replication m a nager, the replication manager logs this error message:
The filename, directory name, or volume label syntax is incorrect for the
operating system associated with this mount point.
Resolution: log on the host and check the filesystemonthehostvolumedevice.Oncethedeviceisclean,
retry the mount command in the replication manager.
UnabletoresumeDRgroup
When attempting to resume a DR group, the replication m anag er logs the message: Unable to
resume DR group <GroupName> because of current state of group for job
<JobName>.
Resolution:
1. In the D R Groups List tab or Tree tab, check the o perational status of the DR group.
6