HP StorageWorks XP24000 Remote Web Console Error Codes, v01 (AE131-96004, June 2007)
Part
Code
Error
Number
Error Messag e
Recommended Ac tion
Severity
Level
Failure
Level
1005 1127
An error occurred. If this
problem persists, please call
technical support.
CHA high-speed mode is
specified to unmounted
CHA.
The error does not
occur normally because it
is guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical support.
E
2
1005 1128
An error occurred. If this
problem persists, please call
technical support.
Channel speed change
is
requested, but Fibre
PCB does not support it.
The error does not occur
normally because it is
guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical support.
E
2
1005 1130
You cann
ot
specify the
default
nickname when
setting
thenicknameofa
host gr
oup
or a host.
Correct
the
specified
content
s, and request again.
E
6
1005 1131
No more host groups can
be
set, because the number
of host groups has reached
the
maximum (254) th at can
be set in a port.
No more host groups can
be
set, because the number
of host groups has reached
the maximum (254) that can
be
set in a por t. Reduce the
number of host groups, then
retry the operation.
E
6
1005 1132
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
aport.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1
005
1
133
Failed to set the host mode
because the number of
host modes exceeds the
maximum that can be set in
aport.
Th
eConfi guration
information has been
already changed.
Please check the settings
a
nd
request the setting of the
configuration information
again.
E
6
1005 1134
Failed to set the path
because the number of
paths exceeds the maximum
that can be set in a por t.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
XP24000 Remote Web Console Error Codes
107