HP StorageWorks XP24000 Remote Web Console Error Codes, v01 (AE131-96004, June 2007)

Part
Code
Error
Number
Error Message
Recommended Action
Severity
Level
Failure
Level
6005 8710
The pair status of the
specified volume is not
valid.
The pair status does not
permit this operation. Verify
the
pair status, and if t he
operation is permitted retry.
i
4
6005 8711
Parameter specified
by Continuous Access
operation for expansion
volume is not valid.
Check the port number,
GID, and LUN of the RCU.
i
4
6005 8712
The operation was rejected
due
to a FREEZE state.
1. If this was a
path
operation r
etry after
the
problem
has
been
fixed.
2. If this
was
a
pair
operation
,
retry after
the
paths
have been
recovere
d.
Two ways to
recover
paths are:
a.
Execute
ESTP ATH
from the
host
consol
e,
or
b.
First d
elete the
path(
s)
from the
SVP, t
hen
re-add
them.
E
4
6005 8713
The port group already
exists on the specified port.
Theporttypecould not
be changed because the
port group was set in the
specified package. Delete
the
group settin g, then
change the port type.
E
4
6005
8714
An internal error occurred.
Please call technical
support.
E
4
6005 8715
Invalid number of paths.
The specified number of
paths is not within the
acceptable path range of
0t
o4. Pleaseverifythe
n
umber of paths and retry
t
he
operation.
E
4
6005 8716
Specified port is not RCP.
Check the configuration of
the
LCP/RCP, then either
specifythe correctportor
change the port to RCP.
E
4
6005 8717
Invalid Destination Link
Address.
The specified logical
address must be either 00
or
01. Check the logical
address and retry the
operation.
E
4
6005 8718
The specified logical path
already exists.
The specified link address
and
port are already in use.
Check all existing logical
path addresses, and specify
another link address or RCP
port.
i
4
198
HP
StorageWorks XP Remote Web Console for Storage System Messages and Error Codes