HP StorageWorks XP24000 Remote Web Console Error Codes, v01 (AE131-96004, June 2007)

Part
Code
Error
Number
Error Messag e
Recommended Ac tion
Severity
Level
Failure
Level
6005 8762
R-VOL Device Cache status
is not
active.
Check the d evice cache
status of
R-VOL from host. If
it is off, setitonand retry.
If it cannot
be set on, call
technical support.
i
4
6005 876 3
R-VOL DFW status is not
active.
Check the DFW status of
the R-VOL from the host. If
it is off, setitonand retry.
If it cannot
be set on, call
technical support.
i
4
6005
87 64
The specifi
ed
R-VOL is
not
usable
,or the device
emulatio
ntypeof the
R-VOL is n
ot
supported by
Continuo
us
Access via serial
interfa
ce.
Please confi
rm
the
status of
th
especified
R-VOL. Ple
ase
see the
OPENPLATF
ORM
SECTION
in the
mai
ntenance manual
to
confirm
whether the
device em
ulation type of
the R-VO
Lissupported by
Continu
ous Access via serial
interfa
ce.
W 4
6005 8766
Continuous Access is not
supported under the R-VOL
Device emulation type.
Thedeviceemulation type of
the R-VOL does not support
Continuous Access. Please
call
technical support.
i
4
6005 876 8
The RCU is still in
another Continuous Access
condition.
The RCU containing the
R-VOL is being used as the
RCU for Continuous Access.
Verify the status of the RCU,
if
necessary delete the RCU,
then retry th e operation.
E
4
6005 8769
The RCU is still in
another Continuous Access
condition.
The RCU containing the
R-VOL is being used as the
RCU
for Continuous Access.
Ver
ify the status of the RCU.
E
4
6005 8770
The Cache on the MCU is
automatically recovering.
Please wait a few minutes
then
retry again.
Click [OK] to acknowledge
the m essage, then retry the
operation after the cache
has been recovered .
i
4
6005 8771
R-VOL option change
operation failed. Only
M-VOL option was modified
because RCU side did
not
support a fence level
displayi ng function.
The R-VOL option change
operation failed (only
the M-VOL option was
modified), because the RCU
side does not support the
display fence level function.
i
4
XP24000 Remote Web Console Error Codes
203