HP StorageWorks XP24000 Remote Web Console Error Codes, v01 (AE131-96004, June 2007)

Part
Code
Error
Number
Error Message
Recommended Action
Severity
Level
Failure
Level
0003
1104
An error occurred during
SVP processing. If this
problem persists, please call
technical support.
If this problem persists, call
technical supp ort.
E
2
0003 1105
An error occurred during
SVP processing. If this
problem persists, please call
technical support.
If this problem persists, call
technical supp ort.
E
2
0003 1108
When changi
ng
the
configuration of the
command
device, you
cannot
set the command
device to the following
volumes:
•
Reserved volumes for
Auto LUN
•
Just-in-Time volumes
•
Volumes other than the
open-system volumes
(including unm ounted
volumes).
Command dev
ice setting
is
requested for Reserve
volume of Auto LUN/Just
in
Time volume. Or it
is
requested for volumes
other
than open volumes
(including uninstalled
volumes). The error does
not
occur normally because
it is
guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical supp ort.
E
2
0003 1110
An error occurred. If this
problem persists, please call
technical support.
If this problem persists, call
technical supp ort.
E
2
0003
1111
An error occurred. If this
problem persists, please call
technical support.
Anicknameisnot specified
when the configuration
change of LUN Manager is
requested. The error does
not
occur normally because
it is
guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical supp ort.
E
2
0003 1113
Th
especified volume is
cu
rrently used by Parallel
Ac
cess Volume and is not
a
vailable for VLL operation.
Change the volumes to
create CV by VLL operation,
retry the VLL setting.
E
6
0003 1116
An error occurred. If this
problem persists, please call
technical support.
You have not specified
the
value when registering
WWN. Or zero is set as
theWWN value. Theerror
does
not occur normally
because it is guarded in
the
screen. In the unlikely
eventthatthiserror occurs,
contact technical support.
E
2
0003 1123
Command device security
cannot be set to the specified
volume because the volume
is not a
command device.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
28
HP
StorageWorks XP Remote Web Console for Storage System Messages and Error Codes