HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

Preparing the Host System
115HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Here you can add a storage subsystem to monitor. You can choose any device as
an access device, however HP StorageWorks recommends that you use the
Command Console LUN devices. It is also recommended that you accept the
default monitoring level of 300 seconds. The monitoring interval is the amount of
time between polls of the monitored subsystems.
Adding storage subsystems
-----------------------------------------------------------
Command Console Access Devices
---------------------------------------------------------------
-
name status location description
hdisk4 Available 20-60-00-0,1 DEC HSG80 RAID Array
hdisk5 Available 20-60-00-0,2 DEC HSG80 RAID Array
hdisk6 Available 20-60-00-0,3 DEC HSG80 RAID Array
hdisk8 Available 20-60-00-1,1 DEC HSG80 RAID Array
hdisk9 Available 20-60-00-1,2 DEC HSG80 RAID Array
hdisk10 Available 20-60-00-1,3 DEC HSG80 RAID Array
hdisk3 Available 20-60-00-0,0 DEC HSG80 Command Console LUN
hdisk7 Available 20-60-00-1,0 DEC HSG80 Command Console LUN
Specify access device to query for information (“hdisk5”):
hdisk3
The following subsystem has been found:
Controller type: HSG80
Firmware version: YC04
Serial numbers: ZG11800073, ZG10707148
EMU type : None installed
Would you like to add this subsystem to the 'storage.ini' file?
Enter a name for this subsystem: raid1
Enter a monitoring interval, in secs
(0 => no monitoring, default is 300):
Would you like to add another subsystem? [y,N]