HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

Installing and Configuring HSG Agent
126 HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Installation and Configuration Overview
Table 13 provides an overview of the installation.
Table 13: Installation and configuration overview
Step Procedure
1 Verify that your hardware has been set up correctly. See the previous
chapters in this guide.
2 Verify that you have a network connection for the Client and Agent systems.
See "About the Network Connection for the Agent", page 127.
3 Verify that there is a LUN for communications. This can be either the CCL or
a LUN that was created with the CLI. See "What is the Command Console
LUN?", page 39, in Chapter 1.
4 Install the Agent (TCP/IP network connections) on a system connected to the
HSG80 controller.
5 Add the name of the Client system to the Agent’s list of Client system entries
(TCP/IP network connections). This can be done during installation or when
reconfiguring the Agent.
6 Install the Client software on Windows 2000 with Service Pack 4 or
Windows NT 4.0 with Service Pack 6A, and Windows Server 2003
(32-bit). See Appendix B.
7 Add the name of the Agent system to the Navigation Tree of each Client
system that is on the Agent’s list of Client system entries (TCP/IP network
connections). See Appendix B.
8 Set up pager notification (TCP/IP network connections). Refer to “Setting Up
Pager Notification” in the
HP StorageWorks Command Console V2.5 User
Guide.