HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

FC Configuration Procedures
136 HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Figure 37: Single controller cabling
Configuring a Single Controller Using CLI
To configure a single controller using CLI involves the following processes:
■ "Establishing Controller Connection", page 136
■ "Configuring Controller Settings", page 137
■ "Setting This Controller", page 137
■ "Setting Time and Verifying All Commands", page 140
■ "Plugging in the FC Cable and Verifying Connections", page 143
■ "Repeating Procedure for Each Host Adapter", page 144
Establishing Controller Connection
1. Establish a serial data connection to the RAID system Controller A from your
host.
2. From the CLI prompt, enter:
SHOW THIS_CONTROLLER FULL
The current configuration of your RAID HSG80 controller opens.
1 Controller
2 Host port 1
3 Host port 2
4 Cable from the switch to the host Fibre Channel
adapter
5 FC switch
CXO6881B
1
5
5
3
2
4
4