HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

FC Configuration Procedures
139HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
13. Restart the controllers for the new settings to take effect, by entering the
following command:
HSG> RESTART OTHER_CONTROLLER
HSG> RESTART THIS_CONTROLLER
14. Change any controller parameter settings inconsistent with those in Table 14
by entering the appropriate command for that parameter, as described in the
following steps.
Note: Ignore the Restart Controller messages until you have finished making all the
required configuration parameter changes.
Note: After completing all of the required parameter changes, you must restart the
controller for the new settings to take effect.
15. To set the prompt to the HSG80 controller, enter:
SET THIS_CONTROLLER PROMPT=”HSG>”
16. Clear the persistent error messages by entering the following command:
HSG> CLEAR CLI
17. Set the node by acquiring the Worldwide Name (WWN) node number and
checksum from the enclosed label (located on the top surface of the controller
enclosure), and by entering the following command:
HSG> SET THIS_CONTROLLER NODE=NNNN-NNNN-NNNN-NNNN CHECKSUM
18. Enable the command console LUN by entering the following command:
HSG> SET THIS_CONTROLLER COMMAND_CONSOLE_LUN
19. Set the port topology offline by entering the following command:
HSG> SET THIS_CONTROLLER PORT_1_TOPOLOGY=OFFLINE
HSG> SET THIS_CONTROLLER PORT_2_TOPOLOGY=OFFLINE
20. Set the port topology by entering the following command:
HSG> SET THIS_CONTROLLER PORT_1_TOPOLOGY=FABRIC
HSG> SET THIS_CONTROLLER PORT_2_TOPOLOGY=FABRIC
See Table 14 for an example of LOOP_HARD topology setup.