HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

FC Configuration Procedures
149HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Note: Further information on command syntax can be found in the HP StorageWorks
HSG60 and HSG80 Array Controller and Array Controller Software Command Line
Interface Reference Guide
.
13. Restart the controllers for the new settings to take effect, by entering the
following command:
HSG> RESTART OTHER_CONTROLLER
HSG> RESTART THIS_CONTROLLER
It takes about a minute for the CLI prompt to come back after a RESTART
command.
Setting Time and Verifying All Commands
14. Set the time on the controller by entering the following syntax:
SET THIS TIME=DD-MMM-YYYY:HH:MM:SS
15. Use the FRUTIL utility to set up the battery discharge timer. Enter the
following command to start FRUTIL:
HSG> RUN FRUTIL
When FRUTIL asks if you intend to replace the battery, answer Y:
Do you intend to replace this controller's cache battery? Y/N
[N] Y
FRUTIL prints out a procedure, but does not give you a prompt. Ignore the
procedure and press Enter.
16. Set up any additional optional controller settings, such as changing the CLI
prompt. See the
SET THIS CONTROLLER/OTHER CONTROLLER command in the HP
StorageWorks HSG60 and HSG80 Array Controller and Array Controller
Software Command Line Interface Reference Guide for the format of optional
settings. Perform this step on both controllers.
17. Verify that all commands have taken effect by entering the following
command:
HSG> SHOW THIS