HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

165HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
6
Using CLI for Configuration
This chapter presents an example of how to configure a storage subsystem using
the Command Line Interpreter (CLI). The CLI configuration example shown
assumes:
■ A normal, new controller pair, which includes:
— NODE ID set
— No previous failover mode
— No previous topology set
■ Two single-bus model 4214R disk enclosure shelves
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 40. The example system
contains three non-clustered AIX hosts, as shown in Figure 41. The resulting
virtual system, from the host’s point of view, is shown in Figure 42.
Figure 40 shows an example storage system map for the BA370 enclosure. Details
on building your own map are described in Chapter 2. Templates to help you build
your storage map are supplied in Appendix A.