HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

FC Configuration Procedures
116 HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
Figure 36: Single controller cabling
Configuring a Single Controller Using CLI
To configure a single controller using CLI involves the following processes:
■ "Verifying the Node ID and Check for Any Previous Connections", page 116
■ "Configuring Controller Settings", page 117
■ "Restarting the Controller", page 118
■ "Setting Time and Verifying All Commands", page 119
■ "Plugging in the FC Cable and Verifying Connections", page 121
■ "Repeating Procedure for Each Host Adapter", page 121
■ "Verifying Installation", page 121
Verifying the Node ID and Check for Any Previous Connections
1. Enter a SHOW THIS command to verify the node ID:
SHOW THIS
See "Worldwide Names (Node IDs and Port IDs)", page 56, for the location
of the sticker.
1 Controller
2 Host port 1
3 Host port 2
4 Cable from the switch to the host Fibre Channel
adapter
5 FC switch
CXO6881B
1
5
5
3
2
4
4