HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

FC Configuration Procedures

142 HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide

SHOW DEVICE-NAME

Note: FULL is not required when showing a particular device. It is used when

showing all devices, for example,

SHOW DEVICES FULL.

Changing RAIDset and Mirrorset Switches

Use the SET storageset-name command to change the RAIDset and Mirrorset switches

associated with an existing storageset.

For example, the following command changes the replacement policy for

RAIDset RAID1 to

BEST_FIT:

SET RAID1 POLICY=BEST_FIT

Changing Device Switches

Use the SET device-name command to change the device switches.

For example, to request a data transfer rate of 20 MHz for DISK10000:

SET DISK10000 TRANSFER_RATE_REQUESTED=20MHZ

Changing Initialize Switches

The initialization switches cannot be changed without destroying the data on the

storageset or device. These switches are integral to the formatting and can only be

changed by reinitializing the storageset. Initializing a storageset is similar to

formatting a disk drive; all data is destroyed during this procedure.

Changing Unit Switches

Use the SET unit-name command to change the characteristics of a unit.

For example, the following command enables write protection for unit D100:

SET D100 WRITE_PROTECT