HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

143HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
6
Using CLI for Configuration
This chapter presents an example of how to configure a storage subsystem using
the Command Line Interpreter (CLI). The CLI configuration example shown
assumes:
■ A normal, new controller pair, which includes:
— NODE ID set
— No previous failover mode
— No previous topology set
■ Full array with no expansion cabinet
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 39. The example system
contains three non-clustered Netware hosts, as shown in Figure 40. From the
hosts’ point of view, each host has four paths to its own virtual disks. The
resulting virtual system, from the host’s point of view, is shown in Figure 41.
Figure 39 shows an example storage system map for the BA370 enclosure. Details
on building your own map are described in Chapter 2. Templates to help you build
your storage map are supplied in Appendix A.