HP StorageWorks HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for Linux X86 Release Notes (AA-RV1KA-TE, March 2005)

ACS Enhancements and Fixes
10 HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for Linux
X86 Release Notes
ACS Enhancements and Fixes
This section covers:
■ New CLI Commands and Switches, page 10
■ Other Enhancements, page 18
■ ACS Fixes, page 23
New CLI Commands and Switches
Table 1 on page 10 lists and describes new Command Line Interface (CLI)
commands included in this release of ACS V8.8-1.
Table 1: New CLI Commands and Switches
Item CLI Command or Switch Description and Background
1.
DEFAULT_ACCESS=ENABLE (default)
DEFAULT_ACCESS=DISABLE
Directs the controller to automatically
disable or enable connections after creating
units through the CLI. This switch is used in
conjunction with the SET
controller
command.
Although the HP StorageWorks HSG
Element Manager and HP StorageWorks
Command Console disable all connections
for units created through their respective
programs, creating new units through the
CLI requires you to manually disable
connections.
2.
SHOW ELEVATION_INFO Combines several existing commands to
allow you to output and transfer relevant
and helpful controller configuration
information needed by HP service
representatives before and during a support
call.
3.
WWID_ASSIGN storageset
LUN_WWID=xx
Assigns World Wide ID (WWID) addresses
to storage containers.