HP StorageWorks HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for Linux X86 Release Notes (AA-RV1KA-TE, March 2005)

Upgrading ACS
8 HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for Linux
X86 Release Notes
Upgrading ACS
To upgrade your ACS firmware to ACS V8.8-1, see the HP StorageWorks HSG60
and HSG80 Array Controller and Array Controller Software Maintenance and
Service Guide. After you upgrade to ACS V8.8-1, you must then complete
specific after-upgrade maintenance checks.
Caution: It is critical that you follow upgrade instructions and perform the
after-upgrade maintenance checks as documented in the HP StorageWorks
HSG60 and HSG80 Array Controller and Array Controller Software
Maintenance and Service Guide to prevent data loss or corruption. If at any
time you encounter problems during the upgrade, contact your HP support
representative.
Caution: If you are upgrading to ACS 8.8-1P (HP StorageWorks Data Replication
Manager) with active Remote Copy Sets, note the following guidelines:
■ Ensure that the latest drivers and Secure Path V3.0A (Service Pack 1) or
Securities V3.0B (Service Pack 1) are installed before upgrading.
■ Complete a shutdown upgrade if you are running Windows NT, Windows
2000, or IBM AIX. Rolling upgrades are not supported on these platforms.
Failure to follow these guidelines can result in undesirable controller upgrade
issues.