Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module
UltraSCSI RAID Enclosure 5–13
5. On the master enclosure
I/O module, align the
Cable A
(C
ALLOUT
A)
connector with the left
connector. Gently insert
the cable connector into
the module connector.
Tighten both cable
connector thumb screws
to fully seat the
connector.
6. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
7. On the master enclosure, align the module that has Cable A
(C
ALLOUT
A) attached with the
Port 1
backplane connector. Gently
insert the module and fully seat it. Use a screwdriver to tighten the
spring-loaded mounting screws.
8. On the expansion I/O
module, align the
Cable A
(C
ALLOUT
A) connector
with the
left
connector
.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
9. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
Table 5–6 Installing Two-Enclosure Subsystem
Cables (Continued)
CXO5854B
A
642
531
A
CXO5854B
A