Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module
UltraSCSI RAID Enclosure 5–19
11. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
12. On the
first
expansion enclosure shroud, align the module that has
Cable B (C
ALLOUT
B) attached with the
Port 1
backplane connector.
Gently insert the module and fully seat it. Use a screwdriver to
tighten the spring-loaded mounting screws.
13. On the
second
expansion
enclosure I/O module,
align the
Cable B
(C
ALLOUT
B) connector
with the
left
connector.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
14. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
Table 5–8 Installing Three-Enclosure Subsystem
Cables (Continued)
642
531
642
531
642
A
B
CXO5854B
A