Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Power Distribution

6–16 UltraSCSI RAID Enclosure

3. Insert the power supply

into the guide slots and

push it in until the bezel

mounting tabs engage

the shelf, fully seating

the power supply.

4. Connect the power cord to the power supply.

5. For a cold swap method, go to step 6 to turn O

the subsystem.

6. If there are no expansion enclosures, go to step 7.

If there are expansion

enclosures, turn O

all the ac

input boxes for each

expansion enclosure by

pressing

on each ac power

switch (C

ALLOUT

1).

7. On the master enclosure,

turn O

all the ac input

boxes by pressing

on each

ac power switch

ALLOUT

1).

8. Verify the array controller places the subsystem into an operational

state.

9. Verify that both power supply status LEDs are O

Table 6–4 Installing a Power Supply (Continued)

CXO-4314A-MC

CXO5488B