HP StorageWorks HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide (AA-RV1RA-TE, March 2005)

FC Configuration Procedures
132 HSG80 ACS Solution Software V8.8 for Sun Solaris Installation and Configuration Guide
Setting Up a Single Controller
Powering On and Establishing Communication
1. Connect the computer or terminal to the controller, as shown in Figure 37.
The connection to the computer is through the COM1 or COM2 port.
2. Turn on the computer or terminal.
3. Apply power to the storage subsystem.
4. Verify that the computer or terminal is configured as follows:
— 9600 baud
— 8 data bits
— 1 stop bit
—no parity
— no flow control
5. Press Enter. A copyright notice and the CLI prompt appear, indicating that
you established a local connection with the controller.
Cabling a Single Controller
The cabling for a single controller is shown in Figure 38.
Note: It is a good idea to plug only the controller cables into the switch. The host
cables are plugged into the switch as part of the configuration procedure
(“Configuring a Single Controller Using CLI” on page 133).