HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 deployment guide (AG421-96001, March 2007)

128 13 - TROUBLESHOOTING DEPLOYMENT PROBLEMS

The following sections describe possible solutions to SMB-signed sessions:

 “Solution: Enable Secure-CIFS” on page 128

 “Solution: Disable SMB Signing with Active Directory” on page 128

For more information, see the HP StorageWorks Enterprise File Services WAN

Accelerator Installation and Configuration Guide.

Solution:

Enable

Secure-CIFS

Enable Secure-CIFS using the CLI command protocol cifs secure-sig-opt enable.

For more information, see the HP StorageWorks Enterprise File Services WAN

Accelerator Installation and Configuration Guide.

Alternatively, to enable secure-CIFS using the Management Console, check the

Optimize Connections with Security Signatures box in the Optimization Service -

Protocol: CIFS page.

NOTE: Secure-CIFS is enabled by default beginning with Version 2.x.

TIP: If a log file shows messages such as

error=SMB_SHUTDOWN_ERR_SEC_SIG_REQUIRED, use the solution described in

“Solution: Disable SMB Signing with Active Directory” on page 128 because enabling

secure-CIFS has no effect when SMB signing has been set to "required".

For details, see the HP EFS WAN Accelerator Management Console Online Help or

the HP Enterprise File Services WAN Accelerator Management Console User Guide.

Solution:

Disable SMB

Signing with

Active Directory

If you have tried enabling Secure-CIFS as described in “Solution: Enable

Secure-CIFS” on page 128 but SMB signing still occurs, consider using Active

Directory to disable SMB signing requirements on servers or clients. For details, see

the HP StorageWorks Enterprise File Services WAN Accelerator Installation and

Configuration Guide.

Similar

Problems