HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 deployment guide (AG421-96001, March 2007)

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR DEPLOYMENT GUIDE 29
2 - IN-PATH DEPLOYMENTS
The following figure illustrates the server-side of the network.
Figure 2-6. In-Path, Server-Side, One-to-One Deployment
Basic Steps
(Client-Side)
The client-side HP EFS WAN Accelerator is configured as an in-path device. For
detailed information, see the HP StorageWorks Enterprise File Services WAN
Accelerator Installation and Configuration Guide.
Basic Steps
(Server-Side)
Perform the following steps for each of the server-side HP EFS WAN Accelerators.
1. Configure the HP EFS WAN Accelerator as an in-path device. For detailed
information, see the HP StorageWorks Enterprise File Services WAN Accelerator
Installation and Configuration Guide.
2. Connect to the Management Console. For detailed information, see the HP
Enterprise File Services WAN Accelerator Management Console User Guide.
3. Navigate to the Setup: Advanced Networking - Failover Settings page in the
Management Console.
4. Enable failover support. For example:
 Select a synchronization mode.
 On HP EFS WAN Accelerator A, specify HP EFS WAN Accelerator A as the
master and specify the in-path IP address of HP EFS WAN Accelerator B as
the backup (other) IP address.