HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 deployment guide (AG421-96001, March 2007)

34 3 - VIRTUAL IN-PATH NETWORK DEPLOYMENTS
 On HP EFS WAN Accelerator B, plug the straight-through cable into the WAN
port of the HP EFS WAN Accelerator and the Layer-4 switch.
5. Connect to the Management Console. For details see the HP Enterprise File
Services WAN Accelerator Management Console User Guide.
6. Navigate to the Setup: Optimization Service - General Settings page in the
Management Console.
7. Enable Layer-4 switch support. For example:
 Click Enable In-Path Support and Enable L4/PBR/WCCP Support on
Interface wan0_0.
Figure 3-2. Setup: Optimization Service - General Settings Page
8. Apply and save the new configuration in the Management Console.
9. Configure your Layer-4 switch. For information, refer to the documentation for
your switch.
10. Restart the HP EFS WAN Accelerator in the Setup: Start/Stop Appliance page of
the Management Console.
11. Begin optimization.
12. View performance reports and system logs in the Management Console.