HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 deployment guide (AG421-96001, March 2007)

62 6 - POLICY-BASED ROUTING DEPLOYMENTS
In this configuration, the HP EFS WAN Accelerator is attached to any Layer-2 switch
that the router can reach (even the same switch as the clients). VLAN trunking is
enabled between the Layer-2 switch and the PBR router (not on the link between the
HP EFS WAN Accelerator and the switch).
In this configuration you use the IP addresses in a single subnet and the router has 2
VLAN interfaces on fastEthernet0/0.
To configure the HP
EFS WAN Accelerator
Use the procedures in “Basic Steps (Client-Side)” on page 56. With a single subnet
configuration, the route-map is attached to a VLAN interface instead of an ethernet
interface.
This example assumes that VLAN trunking is already configured on the Layer-2
switch and the router for the clients VLAN (VLAN1) and that the Layer-2 switch
configuration for VLAN2 is already completed.
To configure the Cisco
router
• On the client-side router, at the system prompt, enter the following set of
commands:
Router#configure terminal
Router(config)#interface fastEthernet 0/0.2
Router(config-subif)#encapsulation dot1Q 2
Router(config-subif)#ip address 10.2.0.1 255.255.0.0
Router(config-subif)#exit
Router(config)#access-list 101 permit tcp any 10.1.0.0 0.0.255.255
Router(config)#interface fastEthernet 0/0.1
Router(config-subif)#encapsulation dot1Q 1
Router(config-subif)#ip address 10.0.0.1 255.255.0.0
Router(config-subif)#ip policy route-map TrafficToS
Router(config-subif)#exit
Router(config)#route-map TrafficToS permit 10
Router(config-route-map)#match ip address 101
Router(config-route-map)#set ip next-hop 10.2.0.2
Router(config-route-map)#end
Router#
TIP: Enter configuration commands, one per line. End with CTRL-Z.