HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 deployment guide (AG421-96001, March 2007)

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR DEPLOYMENT GUIDE 79
7 - WCCP DEPLOYMENTS
Configuring WCCP Using the Management
Console
The following section describes the basic steps for configuring the HP EFS WAN
Accelerator using the Management Console.
This section does not describe how you enable your router for WCCP and create a
service group for the HP EFS WAN Accelerator. For detailed information about
configuring your router, see “Configuring the WCCP Router or Multi-Layer Switch”
on page 77.
In this example, the client-side HP EFS WAN Accelerator IP address 10.1.0.2, its
WAN router is 10.1.0.1, and the server-side HP EFS WAN Accelerator IP address is
10.2.0.2.
Basic Steps
(Client-Side)
Perform the following steps for the client-side HP EFS WAN Accelerator.
1. Configure the HP EFS WAN Accelerator in an in-path configuration. For detailed
information, see the HP StorageWorks Enterprise File Services WAN Accelerator
Installation and Configuration Guide.
2. Connect to the Management Console. For detailed information, see the HP
StorageWorks Enterprise File Services WAN Accelerator Installation and
Configuration Guide.
3. Navigate to the Setup: Optimization Service - General Settings page in the
Management Console.