HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Management Console user guide (AG421-96002, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR MANAGEMENT CONSOLE USER GUIDE 103
2 CONFIGURING THE HP EFS
WAN A
CCELERATOR
To set PFS share
parameters
1. Click the Setup tab to display the Setup menu.
2. Click Proxy File Service to expand the PFS menu.
3. Click Shares to display the Proxy File Service - Shares page.
4. Click Add a new Proxy Share to display the Proxy File Service (PFS) - Shares
page.
Figure 2-40. Proxy File Service - Shares Page
5. Use the controls to complete the configuration, as described in the following table.
Control Description
Local Name Specify the name that you assign to a share on the HP EFS WAN Accelerator. The
maximum length is 80 characters.
IMPORTANT: The PFS share and the origin-server share name cannot contain
Unicode characters. The Management Console does not support Unicode characters.
Remote Path Specify the remote path of the origin file server where the share resides. You must use
the Uniform Naming Convention (UNC) for the mapped drive for v3 shares. For
example, \\<origin-file-server>\<local-name>
IMPORTANT: The PFS share and the origin-server share name cannot contain
Unicode characters. The Management Console does not support Unicode characters.
NOTE: If you created your share with v2.x software, this value represents the name of
the Windows server where the HP EFS Remote Copy Utility (RCU) is running. If the
origin server is not the RCU server, you specify the remote path using the UNC format
for the mapped drive. If the origin server is the same as the RCU server then you must
type its full path including the drive letter, for example C:\data.
Comment Optionally, specify a comment to help you identify the share.