HP StorageWorks Enterprise File Services WAN Accelerator Manager 2.1.2 User's Guide (392360-004, June 2006)

118 5 - MANAGING HP EFS WAN ACCELERATOR MANAGER SETTINGS
Setting SNMP
Traps
You set SNMP traps in the Reports - SNMP Trap Receivers page.
The default setup does not complete SNMP traps.
To set SNMP traps 1. Click the Setup Manager tab to expand the Setup Manager menu.
2. Click Reports in the left menu to expand the Reports menu.
3. Click SNMP Trap Receivers to display the Reports - SNMP Trap Receivers page.
Figure 5-9. Setup Manager: Reports - SNMP Trap Receivers Page
4. Use the controls to configure SNMP trap receivers, as described in the following
table.
5. To save the setting permanently, click Save.
To reset the settings to the HP EFS WAN Accelerator Manager running
configuration, click Reset.
Setting Up
Monitored Ports
You set TCP ports you want to monitor in the Reports - Monitored Ports page.
The default setup monitors traffic on ports 21 (FTP), 80 (HTTP), 139
(CIFS:NetBIOS), 445 (CIFS:TCP), 1433 (SQL:TDS), Radius (1812), TACACS+ (49),
and 7830 (MAPI).
Control Description
Receiver IP Type the IP address for the SNMP trap.
Community Type the SNMP community name.
Type Select v1 or v2c from the drop-down list to specify the SNMP software version.
Enabled Select True to enable or False to disable the trap receiver.
Add Trap Receiver Click Add Trap Receiver to add the configuration to the Trap Receiver list.
Remove Selected Receivers To remove an SNMP receiver from the Trap Receiver list, click the check box next to the
entry and click Remove Selected Receivers.