HP StorageWorks Enterprise File Services WAN Accelerator Manager 2.1.2 User's Guide (392360-004, June 2006)

HP EFS WAN ACCELERATOR MANAGER USER’S GUIDE 163
A - HP EFS WAN
A
CCELERATOR MANAGER
The commands available to you depend on which mode you are in. Entering a question
mark (?) at the system prompt provides a list of commands for each command mode.
Entering
Commands
The CLI accepts abbreviations for commands. The following example is the
abbreviation for the configure terminal command:
tilden # config terminal
You can also press
TAB to complete a CLI command automatically.
Angle
Bracketed
Parameters
This section summarizes the meaning of angle bracketed parameters for the CLI:
 <ifname>. An interface name, for example: eth0 eth1, lo (loopback), and so
forth. This corresponds to the value of the wildcard under /net/interface in the
management node hierarchy.
 <URL>. A typical URL, using any protocol that wget supports, including HTTP,
HTTPS, and FTP; or a pseudo-URL specifying an scp file transfer. The scp
pseudo-URL format is
scp://username:password@hostname/path/filename
The path is an absolute path. Paths relative to the home directory of the user are
not currently supported.
Accessing
Online Help
At the system prompt, type the full or partial command string followed by a question
mark (?). The CLI displays the command keywords or parameters for the command,
and a short description.
To access online help • At the system prompt enter the following command:
tilden (config) # show ?
The CLI does not display the question mark.
Error Messages If the system does not recognize the command or parameter, it displays the following
message:
Mode Access Method System Prompt Exit Method Description
user Each CLI session begins
in user mode.
host > exit • Perform common
network tests such as
ping.
privileged Enter the enable
command at the system
prompt while in user
mode.
host # disable
no enable
• Restart and reboot the
system.
• Display system
information.
• Verify configuration
information.
configuration Enter the configure
terminal command at
the system prompt while
in privileged mode.
host (config) # exit • Configure system
parameters.