HP StorageWorks Enterprise File Services WAN Accelerator Manager 2.1.2 User's Guide (392360-004, June 2006)

26 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR MANAGER

Powering On the HP EFS WAN Accelerator

Manager

This section describes how to connect and power on the HP EFS WAN Accelerator

Manager.

To connect the power

to the HP EFS WAN

Accelerator Manager

1. Plug in the Alternating Current (AC) power cord into the HP StorageWorks

Enterprise File Services WAN Accelerator Manager.

2. Plug in the AC power cord into an uninterrupted AC power source (Figure 2-1 on

page 23, item 3).

3. Press the Power On/Standby button on the front of the HP StorageWorks

Enterprise File Services WAN Accelerator Manager (Figure 2-2 on page 24, item

6).

4. Check the status lights on the front and rear of the HP StorageWorks Enterprise

File Services WAN Accelerator Manager.

Connecting to the HP EFS WAN Accelerator

Manager

This section describes how to access the configuration wizard and command-line

interface (CLI).

To connect to the HP

EFS WAN Accelerator

Manager

1. Plug in the serial cable into the serial connector port on the HP StorageWorks

Enterprise File Services WAN Accelerator Manager (Figure 2-1 on page 23, item

8).

2. Start your terminal emulation program such as Tera Term Pro or HyperTerminal.

The terminal device must have the following settings:

 Baud rate: 9600 bps

 Data bits: 8

 Parity: none

 Stop bits: 1

 No flow control

3. Log in as an administrator. For example:

Sent username "admin"

password: password

4. Check the system and disk status lights. For details, see Figure 2-2 on page 24.