HP StorageWorks Enterprise File Services WAN Accelerator Manager 2.1.2 User's Guide (392360-004, June 2006)

HP EFS WAN ACCELERATOR MANAGER USER’S GUIDE 27
2 - INSTALLING AND
C
ONFIGURING THE HP EFS
Completing the Initial Configuration
This section describes how to complete the initial configuration of the HP EFS WAN
Accelerator Manager.
To configure the HP
EFS WAN Accelerator
Manager
1. After you log in to the HP EFS WAN Accelerator Manager as administrator, the
system prompts you to start the configuration wizard. Enter yes at the system
prompt. For example:
Configuration wizard.
Do you want to use the wizard for initial configuration?
yes
2. Complete the configuration wizard steps as described in the following table.
TIP: Press ENTER to enter the default value. If you mistakenly answer no, you can start the
configuration wizard by entering configuration jump-start at the system prompt.
TIP: Press '?' for help. Press CTRL-B to go back to the previous step.
Wizard Prompt Description Example
Step 1: Hostname? Enter the host name for the HP EFS WAN
Accelerator Manager
.
Step 1: Hostname? minna
Step 2: Use DHCP? You are given the option to enable the
Dynamic Host Configuration Protocol
(DHCP) to automatically assign an IP
address to the primary interface for the HP
EFS WAN Accelerator Manager.
HP recommends that you do not set
DHCP.
The default value is no.
Step 2: Use DHCP? no
(1 of 2)