HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
102 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
I 10. Verify that the subsystem WWN, also called the NODE_ID, is set (if zeros are displayed,
the name is not set):
If the name is set, go to step 13.
If the WWN has not been assigned to the controller, you must obtain the name before
proceeding.
Note: The subsystem’s WWN and checksum are located on a sticker on top of the frame that houses
the controllers, EMU, PVA, and cache modules. This sticker also includes a checksum, which is
required to verify that the WWN is valid. If no label is present, contact your HP customer service
representative for assistance. For more information on WWNs, refer to the
HP StorageWorks HSG80
ACS Solution Software Version 8.7 Installation and Configuration Guide
for your operating system.
Each subsystem’s WWN begins with 5000 and ends in zero; for example, 5000-1FE1-FF0C-EE00.
The controller port IDs are derived from the WWN.
Caution: Never set two subsystems to the same WWN; data corruption will occur.
I 11. After the WWN has been located, assign it to the controller:
SET THIS_CONTROLLER NODE_ID=node_ID checksum
You should see a display similar to that in Example Display 25.
Example Display 25
Warning 4000: A restart of this controller is required before all the
parameters modified will take effect
%CER--HSG80> --09-FEB-1999 10:07:54-- Restart of this controller required
Restart of this controller required
I 12. Issue the SHOW THIS_CONTROLLER command to verify that the WWN is set.
You should see a display similar to that in Example Display 26.
Example Display 26
Controller:
HSG80 ZG8nnnnnnn Software V87-P, Hardware E03
NODE_ID = 5000-nnnn-nnnn-nnn0
ALLOCATION_CLASS = 0
SCSI_VERSION = SCSI-2
Not configured for dual-redundancy
Controller misconfigured -- other controller present
Device Port SCSI address 7
Time: NOT SET
Command Console LUN is disabled