HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
103Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
I 13. Configure the controllers for multiple-bus failover mode:
SET MULTIBUS_FAILOVER COPY=THIS_CONTROLLER
This command automatically restarts the Other controller.
A %LFL and %EVL prompt is displayed. Refer to the HP StorageWorks HSG80 Array
Controller ACS V8.7 Maintenance and Service Guide for more details on these reports.
I 14. Verify that the setting from step 13 has been applied:
SHOW THIS_CONTROLLER FULL
Check the display to verify that the controllers have been configured to support
multiple-bus failover mode.
You should see a display similar to that in Example Display 27.
Example Display 27
Controller:
HSG80 ZG8nnnnnnn Software V87-P, Hardware E03
NODE_ID = nnnn-nnnn-nnnn-nnnn
ALLOCATION_CLASS = 0
SCSI_VERSION = SCSI-2
Configured for MULTIBUS_FAILOVER with ZG8nnnnnnn
In dual-redundant configuration
Device Port SCSI address 7
Time: NOT SET
Command Console LUN is lun 0 (NOIDENTIFIER)
Note: These settings are applied automatically to controller B2. It is not necessary to repeat these
steps on controller B2.
I 15. You must select the SCSI mode for the controllers. Some operating systems support only
one SCSI mode. For more information, refer to the DRM Release Notes.
Set SCSI-3 mode:
SET THIS SCSI=SCSI-3
Note: For OpenVMS, set alloclass and identifier:
SET THIS ALLOCATION_CLASS = 1
SET THIS IDENTIFIER = 99
Setting this switch causes the host to load the SYS$DRIVER, which provides the GG devices. The
value range is 1 - 99.
D0 (D-zero) can no longer be used as a device LUN in SCSI-3 mode.
Set SCSI-2 mode:
SET THIS SCSI=SCSI-2