HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
118 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
I 7. You may set the FAIL_ALL or ORDER_ALL properties of the association set now, if
desired, by issuing the following CLI commands:
SET AssociationSetName FAIL_ALL
SET AssociationSetName ORDER_ALL
Note: If you choose to set the FALL_ALL property of the association set, make sure that all of
the remote copy sets in the association set are set to failsafe error mode. If you choose to use
failsafe error mode, you cannot use a log unit.
Configure the Host at the Initiator Site
This section describes how to set up your host systems at the initiator site. Follow the
procedures for each operating system present in your SAN:
■ HP OpenVMS, page 118
■ HP Tru64 UNIX, page 121
■ HP-UX‚ page 123
■ IBM AIX, page 126
■ Microsoft Windows NT and Windows 2000, page 134
■ Novell NetWare, page 137
■ Sun Solaris, page 141
HP OpenVMS
Before beginning this procedure, make sure that your host is up to date with service packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
I You must install at least two HBAs in each host system. Record the HBA WWID for use later
in this section. Refer to the Compaq StorageWorks 64-Bit PCI-to-Fibre Channel Host Bus
Adapter User Guide for installation instructions. The user guide is located at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html.
Note: Do not attach your fiber connections to the HBAs until instructed to do so.
Install SWCC (Optional)
I You may now install SWCC. For detailed information about SWCC, including installation,
refer to the Compaq StorageWorks Command Console Version 2.4 User Guide.