HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)
Configuring a Standard Data Replication Manager Solution
120 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
I 2. When you have completed the worksheet, rename the connections:
RENAME !NEWCONxx InitiatorHostConnectionNamex
RENAME !NEWCONxx InitiatorHostConnectionNamey
Example: rename !NEWCONxx HostA1
Example: rename !NEWCONxx HostA2
I 3. Set the operating system for each connection to OpenVMS:
SET InitiatorHostConnectionNamex OPERATING_SYSTEM=VMS
Example: set HostA1 operating_system = vms
Example: set HostA2 operating_system = vms
I 4. When you have finished naming your host connections, issue the following command to
verify your new settings:
SHOW CONNECTIONS
You should see a display similar to that in Example Display 40.
Example Display 40
Connection Unit
Name Operating system Controller Port Address Status Offset
HostA1 VMS THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
HostA2 VMS OTHER 1 200013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
Update Switch Zones
The switch zones created at the target site must be updated with the host connection
information (refer to Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for
detailed information on zone creation):
I 1. On the top fabric, add the host connection to the zone that contains port 1 of the top
initiator controller.
I 2. On the bottom fabric, add the host connection to the zone that contains port 1 of bottom
the initiator controller.
Enable Access to the Hosts at the Initiator Site
I The initiator units must have access to the hosts. Enable access with the following CLI
command:
SET UnitName ENABLE_ACCESS_PATH=(InitiatorHostConnectionNamex,
InitiatorHostConnectionNamey)
Example: set unitname enable_access_path=(HostA1,HostA2)
Repeat this step for all units.
Your OpenVMS host is now configured to use DRM. Follow this procedure for each
OpenVMS host present at the initiator site. After configuring the initiator site hosts, go to the
section titled “Additional Host Configuration,” on page 144.