HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
125Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
I 3. Change the operating system for each connection to HP-UX:
SET !NEWCONxx operating_system=hp
I 4. After you have renamed the host connections, issue the following command to see the new
settings:
SHOW CONNECTIONS
Update Switch Zones
The switch zones created earlier must be updated with the host connection information:
I 1. On the top fabric, add the host connection to the zone that contains port 1 of the top target
controller.
I 2. On the bottom fabric, add the host connection to the zone that contains port 1 of the
bottom target controller.
Enable Access to the Hosts at the Initiator Site
I The initiator hosts must have access to the units. Enable access with the following command:
SET UnitName ENABLE_ACCESS_PATH=InitiatorHostConnectionNamex,
InitiatorHostConnectionNamey
Example: set UnitName enable_access_path=HostA1,HostA2
Repeat this step for each unit.
Install the Secure Path Fibre Channel HBA Device Driver
I Install the Secure Path Fibre Channel HBA device driver according to the instructions in the
current version of the HP StorageWorks Secure Path for HP-UX Installation and Reference
Guide.
Verify the Disks
I 1. Verify that the disks are present by issuing the following command:
ioscan -fnCdisk
The output should be similar to that shown in Example Display 44.
Example Display 44
Class I H/W Path Driver S/W State H/W Type Description
disk 0 0/0/1/1.2.0 sdisk CLAIMED DEVICE SEAGATE ST39204LC
/dev/dsk/c1t2d0 /dev/rdsk/c1t2d0
disk 1 0/0/255.0.0.0 sdisk CLAIMED DEVICE HSG80 LUN
0x60001FE100080D100009834019820144
/dev/dsk/c8t0d0 /dev/rdsk/c8t0d0
Note: If the device special files (that is, /dev/dsk/c8t0d0, /dev/rdsk/c8t0d0) are not displayed,
then issue command insf -e to install special files and repeat the command ioscan
-fnCdisk.